There will come a time when your water heater will finally give up after months or even years of no maintenance. The first thing you should do is to contact a local plumber to help you fix your heater. However, if you are the type to do things yourself then you can read on about hot water heater installation.
A How-to-Guide on Hot Water Heater Installation
You have now decided to install your own heater, the first thing you should do for hot water heater installation is to find a quality heater. You can browse the internet or visit your local store to find the best possible hot water heater for your home.
You should find a replacement that uses the same fuel and the same parts so that you will not have a hard time during the hot water heater installation. If you want to increase the capacity of your water gallon you can do so as long as there is ample space between the heater and your wall.
The next step in hot water heater installation is preparing the area for the replacement heater. You must check the plumbing and find out if the pipes are connected properly to one another. You must be able to tell the difference between the cold and hot pipes in your plumbing system. Find out if there is a water shutoff for the cold water pipe and a connector for the hot water pipe.
The next step in hot water heater installation is setting up the heater. You can bring the hot water heater down to the heater area with a little help from your friends. Once you have set up the heater, turn off all of the other utilities in the area to make installation smoother and avoid accidents. Turn off valves and switches to ensure your safety in hot water heater installation.
The next step in hot water heater installation is draining all of the water remaining inside the tank. Once drained of water, it is time to disconnect all of the utility lines that connect to your gas line and heater.
Everything is set to go once the connections have been removed, so once that’s done, it is time to place the new heater in the old heater’s area. The heater is now in place and it is time to place all of the fittings.
The last step to your hot water heater installation is reconnecting all of the lines you have previously removed. Once they are connected again you can attach the flue and turn the heater on.